X520 Auto AC Recovery Machine Refrigeration Flushing Machine 600min

Product Instruction

Drain compressor oil automatically;

Can you reuse recovered refrigerant ?

A technician may recover refrigerant from an owner's equipment and recharge equipment belonging to that same owner with the recovered material . The technician can also recycle the recovered refrigerant , which involves extracting and cleaning it for reuse without meeting the requirements for reclamation .

Features

a . Recycled : Separation of oil and water from , the recovered refrigerant meets the standard of SAE , thus it can be reused for the vehicles air conditioning .
b . High / Low Pressure protection .
c . Separate compressor oil from the refrigerant and charge new oil .
d . Filling : New oil and refrigerant refilling can be easily set up .

g . Equipped with filter device to eliminate moisture and impurities .

h. Oil Inject: Automatically inject oil back into the vehicle’s A/C systems.

i. Vacuum Feature: Defaults to 15 mins, programmable up to 99 mins. “Remaining time” is displayed.

j. Equipped with filter device to eliminate moisture and impurities .

Technical specifications

Refrigerant Recovery Procedure

Using a recovery/recycling machine is not difficult. The basic procedure goes as follows:

1. Connect the hoses on the recovery machine to the service fitting on the vehicle.
2. Turn the recovery unit on following the equipment manufacturer's operating instructions. Allow the machine to continue pulling refrigerant from the system until it indicates all of the refrigerant has been recovered (system pressure reads vacuum and holds vacuum for at least 5 minutes). If the machine does not have an automatic timer or shut-off, discontinue recovery at this time, and close and disconnect the service hoses.

TIP: If A/C components show evidence of icing during the recovery process, the components can be gently heated to speed up the flow of refrigerant. Use a hot air blow dryer, never any type of open flame, to heat parts.

3. Once the recovery process is complete, determine how much oil was pulled out along with the refrigerant so you can replace it when the system is recharged. Most machines have an oil cup that will show how much oil was taken out. The cup should usually have about one ounce of oil in it if the system contains the proper amount of oil. If the system is low on oil, there may be little or no oil in the cup. On the other hand, if the system is overcharged with oil, there may be several ounces of oil in the cup.

4. After the refrigerant has been recovered, the recycling process can begin. The time it takes to clean the refrigerant can vary from 20 minutes up to an hour depending on the amount of contamination. During the recycling phase, the refrigerant is filtered and dried. Particulates, moisture, oil and air are all removed until the refrigerant meets purity standards. A moisture indicator light usually signals when the job is done. The refrigerant can then be put back into the vehicle, or saved and reused in another vehicle.
Most machines use "single-pass" recycling where the refrigerant makes only one pass through the cleaning circuit, but some machines also offer "multi-pass" recycling or a choice of single-pass or multi-pass cleaning.

Our service

1. OEM Manufacturing welcome : Logo , Product , Package. Aftersale-service.

2. After sending, we will track the products for you once every two days , until you get the products.

3. We can send the goods to you within 2 working days after deposit or 100% payment into our bank account . If we don't have stock , the time to make each product is different generally , it takes 1 to 30 working days .

4. We have a one year guaranty , if the products does not work property as decribed , and the problem is proven to be at our fault , we will provide exchange services for the same specific item.

5. Online Technical support

A professional technical team help to solve customer technical problems .

Guide customers to find out where the problem lies, and provide solutions , try to achieve telephone and remote resolution , and make a good record of the problem , ask customer satisfaction after consultation.